SOFT Comfort VW

The program includes advanced diagnostics of on-Board electronics of cars (coding, adaptation, change of values, etc.) VW,Skoda,Audi,Seat.

The software is in English only!

The diagnostic tool for Volkswagen Group vehicles provides you with safety through all diagnostic procedures-from reading fault codes to testing the outputs of the control unit. Supports both old control units and the latest CAN bus connections. Features:messages:a list of all supported control unitscommunicates via k-line and UDS Protocol CANVAG now also supportedmore of support in our list of supported carsBasic functions:identificationtrouble codes reading / Erasure - including schedule printingmeasured values - displays values in a graphical form, including saving test ridecontrol unit output test-unitadaptation control relay test - can individually agree on some unitlogin / access control parameters - allow you to perform protected functioncoding-coding of the control unit depending on the vehicle equipmentrecommedned solution to the trouble codesengine procedures to change the code. Comfort functions: the comfort function allows you to do some special procedures that requires increased knowledge. You can do this procedures now without the risk of dammaging the control unit.key programmingresetting service intervals (on) long intervals IN1, QG2) adaptation control unit-when switching the control unit or immobilizer unitstart fuel volume to TDI-correction of start-up fuel quantity improves hot start-up of processbasic installation from lightingactivation car by corner function. Special message:AutoTest - testing of all available control units in the car, read fault codes, error displayinginsert address manually establishes connection with the control unit, which is not present in the list of available unitsgateway services - special instructions for control units on CAN-BUSengine electronics - parallel connection with all the engine control units present in the vehicle.