T045 - Chip VAZ

Chip for cars VAZ PCF7936 (working) prepared for entry into the car. Applicable for cars GRANTA, PRIORA, KALINA, CHEVROLET NIVA. The immobilizer training procedure is as follows: A. Close all the car doors. Turn on the ignition with the learning key and wait at least 6 seconds when it is on. V. Turn off the ignition. The lamp should start flashing quickly (5 times per second) as long as the learning procedure is correctly performed. The termination of fast blinking of a lamp means wrong action, going beyond the time interval or malfunction. Remove the training key from the ignition. C. While the lamp is flashing (about 6 seconds) it is necessary to insert the working key into the lock and turn on the ignition. If done correctly, the buzzer will sound three beeps when the ignition is turned on. D. Wait with the ignition on (about 6 seconds) before the buzzer sounds two more beeps. If after 6 seconds the buzzer did not sound any beeps, and the rapid flashing of the light has stopped, then it is necessary to turn off the ignition and start the procedure again. If the situation repeats, it means a malfunction or that this working key has already been trained with another immobilizer. E. Turn off the ignition. F. If it is necessary to train the second working key, then it is necessary to fulfill points C ... E once again, using the second trained working key to switch on the ignition. If not, continue execution from point G. G. While the lamp is flashing (about 6 seconds), it is necessary to remove the key from the ignition lock, insert the training key again into the lock and turn on the ignition. If done correctly, the buzzer will sound three beeps when the ignition is turned on. N. Wait with the ignition on (about 6 seconds) before the buzzer sounds two more beeps. I. Turn off the ignition. Do not remove the training key from the ignition. Approximately 6 seconds after the ignition is turned off, the buzzer should sound a single beep and the lamp should start blinking twice as fast. If the buzzer does not sound the buzzer and the fast blinking of the light has stopped, then you must turn off the ignition and start the procedure again. If the situation repeats, it means a malfunction or that this training key does not fit the controller. J. No later than 6 seconds after the sound signal (while the lamp is flashing rapidly) it is necessary to switch on the ignition with the same training key. After waiting for 2-3 seconds, turn off the ignition. No later than 5 seconds after the ignition is turned off, the buzzer should sound three beeps, and the light should stop fast flashing. Do not turn on the ignition for at least 10 seconds. When working with some controllers, the flashing of the light bulb and the buzzer issuing 3 beeps occur when the ignition is turned on. In this case, you should still turn off the ignition and wait at least 10 seconds. Upon completion of the training procedure, it may be necessary to resynchronize the immobilizer codes and the controller. This means that after the end of the learning procedure, the controller will not allow the engine to start when the ignition is first turned on. To perform resynchronization, you must turn on the ignition with any trained key (preferably a worker). Wait 6 seconds. If the immobilizer light shows an error condition (flashes 1 time per second), then turn off the ignition and wait at least 10 seconds. After that, turn on the ignition again. The lamp should not blink and the engine should start. If 3 seconds after the ignition is switched on, the light bulb lights up with a constant light, this means that the controller has not activated the anti-theft function and the learning procedure should be repeated anew.